风沙条件下颗粒对翼型流动分离的影响

兰州理工大学学报 ›› 2020, Vol. 46 ›› Issue (4): 62-66.

风沙条件下颗粒对翼型流动分离的影响

李仁年^1,2,3, 赵振希¹, 李德顺^1,2,3, 李银然^1,2,3, 王亚娥¹, 郭兴铎¹

1.兰州理工大学能源与动力工程学院, 甘肃兰州 730050;
2.兰州理工大学甘肃省流体机械及系统重点实验室, 甘肃兰州 730050;
3.兰州理工大学甘肃省风力机工程技术研究中心, 甘肃兰州 730050

收稿日期:2018-03-06 出版日期:2020-08-28 发布日期:2020-11-10
作者简介:李仁年(1963-),男,甘肃民勤人,教授,博导.
基金资助:
国家自然科学基金(51766009,51566011),国家重点基础研究发展计划(973 计划) (2014CB046201)

The effect of particles on the separation flow around airfoil in dusty environment

LI Ren-nian^1,2,3, ZHAO Zhen-xi¹, LI De-shun^1,2,3, LI Yin-ran^1,2,3, WANG Ya-e¹, GUO Xing-duo¹

1. College of Energy and Power Engineering, Lanzhou Univ. of Tech., Lanzhou 730050, China;
2. Key Laboratory of Fluid Machinery and Systems of Gansu Province, Lanzhou Univ. of Tech., Lanzhou 730050, China;
3. Research Centre of Wind Turbine Engineering and Technology of Gansu Province, Lanzhou Univ. of Tech., Lanzhou 730050, China

Received:2018-03-06 Online:2020-08-28 Published:2020-11-10

摘要/Abstract

摘要： 运用延迟脱体涡模拟(delayed detached eddy simulation,DDES)技术对NREL S809三维翼型在洁净空气环境中和在不同直径颗粒环境下进行了数值模拟,由此预测了风沙环境下颗粒对翼型绕流分离的影响.研究结果表明:当攻角为8°时,DDES捕捉到了翼型吸力面的涡脱落现象,并且颗粒的加入显著地改变了翼型吸力面的涡脱规律,使得尾涡范围扩大、耗散更快,然而随着颗粒直径的增大,尾涡也逐渐恢复到接近洁净空气时的状态;当攻角较小(6°)时,翼型表面没有发生流动分离,颗粒的加入对流场的影响很小;当攻角较大(12°)时,颗粒对翼型绕流的影响也很小;不同攻角下颗粒对翼型升力系数有不同程度的影响.分析不同攻角下颗粒对翼型表面流动分离的影响规律表明:S809翼型绕流情况受颗粒影响最严重的攻角在7°~10°.

关键词: 风力机, 翼型, 风沙环境, 流动分离, 数值模拟

Abstract: A delayed detached eddy simulation method is employed for the numerical simulation of flows around NREL S809 3D airfoil in clean air and various dusty environment with particles of different diameters. The effect of particle on the flow separation of airfoil was studied. It is shown that at an attacking angle of 8°, DDES has demonstrated the eddy shedding on the suction surface of the airfoil, and addition of particles significantly changes the regularity of eddy shedding on the suction surface of the airfoil, thus enlarging the range of the rear eddy and dissipating it faster. However, with the increase of particle diameter, the tail eddy gradually returns to the state closer to that of clean air. When the attacking angle is less than 6°, there is no flow separation on the surface of the airfoil, and the particles have little effect on the flow region. When the attacking angle is greater than 12°, the particles have even more little effect on the flow around the airfoil. Particles at different attacking angles have different effects on lift factor of the wing. The analysis of the effect of particles on the flow separation on the airfoil surface at different attacking angles shows that the attacking angle most affected seriously by particles is between 7°to 10°.

Key words: wind turbine, airfoil, dusty environment, flow separation, numerical simulation

中图分类号:

TK83

李仁年, 赵振希, 李德顺, 李银然, 王亚娥, 郭兴铎. 风沙条件下颗粒对翼型流动分离的影响[J]. 兰州理工大学学报, 2020, 46(4): 62-66.

LI Ren-nian, ZHAO Zhen-xi, LI De-shun, LI Yin-ran, WANG Ya-e, GUO Xing-duo. The effect of particles on the separation flow around airfoil in dusty environment[J]. Journal of Lanzhou University of Technology, 2020, 46(4): 62-66.

参考文献

[1] LEVY Y,LOCKWOOD F.Velocity measurements in a particle laden turbulent free jet [J].Combustion and Flame,1981,40(3):333-339.
[2] LSUJI Y,MORIKAWA Y.LDV measurements of an air-solid two-phase flow in a vertical pipe [J].Journal of Fluid Mechanics,1984,139(120):417-434.
[3] GORE R,CROWE C.Effect of particle size on modulating turbulent intensity [J].International Journal of Multiphase Flow,1989,15(2):279-285.
[4] 何平,胡丹梅,陈乃超.海上风力机的数值模拟 [J].可再生能源,2010,28(4):21-24.
[5] 李德顺,董麟,刘宜,等.风沙环境对NACA-0012翼型气动性能的影响 [J].兰州理工大学学报,2015,41(6):54-59.
[6] KHAKPOUR Y,BARDAKJI S,NAIR S.Aerodynamic performance of wind turbine blades in dusty environments [C]//ASME 2007 International Mechanical Engineering Congress and Exposition.Wasington:IMECE,2007:483-491.
[7] 刘阳,许春晓,周力行,等.气固流动大涡模拟和两相湍流模型的评价 [J].清华大学学报(自然科学版),2009,49(2):297-300.
[8] 胡偶,赵宁,沈志伟.SST-DDES模型在大分离流动问题中的应用 [J].南京航空航天大学学报,2017,49(2):206-211.
[9] 刘周,杨云军,周伟江,等.基于RANS-LES混合方法的翼型大迎角非定常分离流动研究 [J].航空学报,2014,35(2):372-380.
[10] 刘健,蒋永,吴金华.基于iDDES的双三角翼大迎角非定常涡破裂特征分析 [J].工程力学,2016,33(4):241-249.
[11] 杨从新,金开,王秀勇.一种风力机专用翼型气动性能的三维数值模拟 [J].兰州理工大学学报,2012,38(6):39-43.
[12] 钟伟,王同光.湍流模型封闭常数对S系列翼型CFD模拟的影响 [J].太阳能学报,2013,34(10):1690-1696.
[13] 文晓庆,柳阳威,方乐,等.提高k-ω SST模型对翼型失速特性的模拟能力 [J].北京航空航天大学学报,2013,39(8):1127-1132.
[14] HAND M,SIMMS D,FINGERSH L,et al.Unsteady aerodynamics experiment phase VI:wind tunnel test configurations and available data campaigns [R].Golden,Colorado:National Renewable Energy Laboratory,2001.

[1]	郑玉明, 何正文. 基于竹子生物特征的维管束结构塔筒力学特性研究[J]. 兰州理工大学学报, 2023, 49(3): 49-54.
[2]	殷翔, 马成燕, 周凯, 王新民, 王毅, 王晓军. 管板接头残余应力的数值模拟计算及测试[J]. 兰州理工大学学报, 2023, 49(2): 30-34.
[3]	赵万勇, 曹李健, 王东伟, 胡嘉俊. 自吸式离心泵自吸过程的非稳态数值模拟[J]. 兰州理工大学学报, 2023, 49(2): 35-40.
[4]	任晓敏, 刘俊杰, 刘俊伟, 王晨. 滨海沼泽区地铁车站深基坑开挖变形[J]. 兰州理工大学学报, 2023, 49(2): 138-143.
[5]	黄雪峰, 张吉禄, 周俊鹏, 韦林辉, 袁俊, 王学明. 根键桩抗拔承载特性分析及变形预测[J]. 兰州理工大学学报, 2023, 49(1): 119-126.
[6]	张伟, 乔雄, 骆维斌, 王延文, 田过勤, 倪伟淋, 刘文高. 分部开挖法施工隧道中隔壁优化研究[J]. 兰州理工大学学报, 2022, 48(6): 127-135.
[7]	冯睿, 王磊, 陆万全, 王光宇, 乔及森. 焊剂片约束电弧焊T形接头温度场有限元模拟[J]. 兰州理工大学学报, 2022, 48(5): 1-7.
[8]	赵伟国, 薛子阳, 亢艳东, 程超, 李清华. 叶片开槽对轴流泵空化性能的影响[J]. 兰州理工大学学报, 2022, 48(4): 49-55.
[9]	李琳, 董博, 郑玉巧. 大型风力机异常功率数据清洗方法[J]. 兰州理工大学学报, 2022, 48(3): 65-70.
[10]	徐姚兴, 韦尧兵, 刘俭辉. GFRP层合板近缘和边缘低速冲击损伤数值模拟研究[J]. 兰州理工大学学报, 2022, 48(1): 30-38.
[11]	王靛, 杨从新, 王印, 张根豪, 巫发明, 丁佰岑. 高海拔单台大型风力机外场实验[J]. 兰州理工大学学报, 2022, 48(1): 45-52.
[12]	杨瑞, 周楠楠, 温威月, 杨伟, 顾恩鑫. 前缘辅助小翼对风力机翼型气动性能的影响[J]. 兰州理工大学学报, 2022, 48(1): 53-58.
[13]	杨文伟, 罗进财, 杜亚男. 户外大型三面单立柱广告牌抗风性能气动优化[J]. 兰州理工大学学报, 2022, 48(1): 143-149.
[14]	杨瑞,温威月,周楠楠,杨伟,顾恩鑫. 叶尖开孔对风力机流场的影响研究[J]. 兰州理工大学学报, 2021, 47(6): 38-44.
[15]	郑玉巧,刘玉涵,何正文,董博,魏剑峰. 基于QM-DBSCAN的风力机数据清洗方法[J]. 兰州理工大学学报, 2021, 47(6): 50-55.