兰州理工大学学报 ›› 2022, Vol. 48 ›› Issue (5): 30-34.

• 材料科学与工程 • 上一篇    下一篇

MoO3掺杂有机半导体NPB光电性质研究

赵玉康1, 苏江森1, 吴有智*1, 张材荣2   

  1. 1.兰州理工大学 材料科学与工程学院, 甘肃 兰州 730050;
    2.兰州理工大学 理学院, 甘肃 兰州 730050
  • 收稿日期:2022-01-19 出版日期:2022-10-28 发布日期:2022-11-21
  • 通讯作者: 吴有智(1965-),男,甘肃靖远人,博士,教授. Email:youzhiwu@163.com
  • 基金资助:
    国家自然科学基金(11964016)

Study of optical and electrical properties of MoO3doped organic semiconductor NPB

ZHAO Yu-kang1, SU Jiang-sen1, WU You-zhi1, ZHANG Cai-rong2   

  1. 1. School of Materials Science & Engineering, Lanzhou Univ. of Tech., Lanzhou 730050, China;
    2. School of Science, Lanzhou Univ. of Tech., Lanzhou 730050, China
  • Received:2022-01-19 Online:2022-10-28 Published:2022-11-21

摘要: 在典型有机空穴传输材料胺类衍生物NPB(N,N'-diphenyl-N,N'-bis(1-naphthyl) (1,1'-biphenyl)-4,4'diamine)中引入过渡金属氧化物MoO3制备了只有空穴传输的单载流子器件.结果表明:MoO3的引入明显提升了NPB的导电性能,在约2.0 V的外加电压下,100 nm厚纯NPB薄膜电流密度仅为1.28 mA/cm2,而同样厚度的掺杂薄膜NPB∶MoO3 (50 wt.%)电流密度达到了2 530 mA/cm2.同样掺杂比例的NPB∶MoO3薄膜吸收谱显示位于500 nm附近存在既不同于NPB也不同于MoO3的额外吸收峰,表明体系中产生了电荷转移复合物NPB-MoO-3,从而产生了额外的空穴载流子,进而提升了掺杂体系的导电性能.进一步的荧光分析表明,MoO3的引入对NPB自身荧光具有明显的猝灭作用.NPB∶MoO3(30 wt.%)薄膜的荧光强度比纯NPB薄膜荧光强度降低了2个数量级,NPB∶MoO3 (50 wt.%)掺杂薄膜的荧光强度降低为零.

关键词: 有机半导体, NPB, MoO3, 电荷转移复合物, 猝灭

Abstract: Hole only single carrier devices were prepared by introducing transition metal oxide MoO3 into the typical organic hole transport material amine derivative NPB (N,N'-diphenyl-N,N'-bis(1-naphthyl) (1,1'-biphenyl)-4,4'diamine). The results showed that the introduction of MoO3 significantly enhances the conductivity of NPB, at an applied voltage of about 2.0 V, thecurrent density for a 100-nm-thick pure NPB device is only 1.28 mA/cm2, while that for NPB∶MoO3 (50 wt.%) device with the same film thickness is as high as 2 530 mA/cm2. The absorption spectrum of the NPB∶MoO3 film with the same doping ratio showed that there is an additional absorption peak near 500 nm, which is different from that of NPB or MoO3, indicating that a charge transfer complex NPB+-MoO-3 has been formed in the doped system, resulting in additional hole carriers and thus enhancing the conductivity of the doped film. Further fluorescence analysis showed that the introduction of MoO3 has a significant quenching effect on the fluorescence of NPB. The fluorescence intensity of the NPB∶MoO3 (30 wt.%) films is reduced by two orders of magnitude compared to the pure NPB films, while that of the NPB∶MoO3 (50 wt.%) film was essentially reduced to zero.

Key words: organic semiconductor, NPB, MoO3, charge-transfer complex, quenching

中图分类号: