运动副间隙对涡旋压缩机切向泄漏间隙的影响

兰州理工大学学报 ›› 2020, Vol. 46 ›› Issue (1): 37-43.

运动副间隙对涡旋压缩机切向泄漏间隙的影响

赵嫚, 闫鹏举, 张强

兰州理工大学石油化工学院, 甘肃兰州 730050

收稿日期:2018-01-12 出版日期:2020-02-28 发布日期:2020-06-23
作者简介:赵嫚(1979-),女,吉林双阳人,副教授.
基金资助:
国家自然科学基金(51265026,51265027)

Effect of kinematic pair clearance in scroll compressor on its tangential leakage gap

ZHAO Man, YAN Peng-ju, ZHANG Qiang

College of Petrochemical Technology, Lanzhou Univ. of Tech. , Lanzhou 730050, China

Received:2018-01-12 Online:2020-02-28 Published:2020-06-23

摘要/Abstract

摘要： 针对曲柄销防自转机构涡旋压缩机运动副间隙引起的切向泄漏问题,基于机构学原理简化的平行四杆机构模型,利用连续接触模型,将含间隙的机构转化为多构件多自由度无间隙的机构进行分析,并借助Matlab数值分析软件得出防自转曲柄销处间隙值对动涡旋自转角及切向泄漏间隙的影响.结果表明:动涡盘自转使得泄漏间隙变化量随主轴转角周期性变化,且随着间隙值的增大而增大;反向自转形成的负值间隙变化量使动静涡旋齿磨损增大.因此,在压缩机设计时应严格选用配合公差,减少配合间隙带来的不利影响.

关键词: 涡旋压缩机, 运动副, 间隙, 平行四连杆机构

Abstract: Aimed at the problem of tangential leakage caused by kinematic pair clearance in scroll compressor with autorotation prevention mechanism of crankshaft pin and based on the parallel four-bar linkage model simplified with principle of mechanism, a mechanism with clearance in itself is converted into one with multiple components, multiple degrees of freedom and no gap, and analyzed there after, so that the influence of the clearance magnitude at anti-rotation crank pin on the autorotation angle and tangential leakage gap is determined with the help of Matlab numerical analysis software. The results show that the autorotation of the movable scroll disk will make the magnitude of leakage gap to change periodically with the rotation angle of the spindle and increase with the increase of the gap magnitude. The amount of change of the negative gap caused by the reverse rotation will make the wear of the movable and static scroll teeth increased. Therefore in the design stage of the compressor, the fitting tolerances should be strictly selected to reduce the adverse effect of the fitting clearance.

Key words: scroll compressor, kinematic pair, clearance, parallel four-bar linkage

中图分类号:

TH45

赵嫚, 闫鹏举, 张强. 运动副间隙对涡旋压缩机切向泄漏间隙的影响[J]. 兰州理工大学学报, 2020, 46(1): 37-43.

ZHAO Man, YAN Peng-ju, ZHANG Qiang. Effect of kinematic pair clearance in scroll compressor on its tangential leakage gap[J]. Journal of Lanzhou University of Technology, 2020, 46(1): 37-43.

参考文献

[1] 樊灵,靳春梅,屈宗长,等.通用型线涡旋压缩机的误差和运动分析 [J].机械工程学报,2002,38(6):139-143.
[2] 樊灵,靳春梅,屈宗长,等.涡旋压缩机型线的误差灵敏度与径向啮合间隙的相关分析 [J].机械工程学报,2003,39(4):151-154.
[3] 刘振全,赵嫚,李超.涡旋压缩机曲柄销防自转机构分析 [J].兰州理工大学学报,2006,32(4):53-55.
[4] 李超,赵荣珍,刘振全.涡旋压缩机机构误差对密封间隙的影响分析 [J].润滑与密封,2007,32(7):66-68.
[5] 吴焕芹,程强,钟诗清.含间隙的平面四杆机构运动特性分析 [J].武汉理工大学学报(信息与管理工程版),2010,32(3):419-422.
[6] 郭惠昕,岳文辉.含间隙平面连杆机构运动精度的稳健优化设计 [J].机械工程学报,2012,48(3):75-81.
[7] 李超,刘小菲,李国永,等.考虑机构误差和运动副磨损的涡旋压缩机可靠性分析 [J].兰州理工大学学报,2016,42(3):46-50.
[8] 黄华军,张春,金鑫,等.含运动副间隙的涡旋压缩机动平衡仿真研究 [J].振动与冲击,2016,35(5):125-130.
[9] HORIE M,FUNABASHI H,OGAWA K.Dynamic characteristics of planar link mechanisms with clearances during accelerated and decelerated motions [J].Transactions of the Japan Society of Mechanical Engineers,1986,52:3309-3316.
[10] FLORES P,AMBRÓSIO J,CLARO J C P,et al.A study on dynamics of mechanical systems including joints with clearance and lubrication [J].Mechanism & Machine Theory,2006,41(3):247-261.
[11] FLORES P,AMBRÓSIO J,CLARO J P.Dynamic analysis for planar multibody mechanical systems with lubricated joints [J].Multibody System Dynamics,2004,12(1):47-74.
[12] EDWARDB M.MATLAB原理与工程应用 [M].北京:电子工业出版社,2006.
[13] 李小燕.考虑运动副间隙的平面四杆机构动力学建模与仿真[D].西安:西安电子科技大学,2008.
[14] 郭仁生.机械工程设计分析和MATLAB应用 [M].北京:机械工业出版社,2014.