Preparation and tribological properties of Ni60 composite  coating modified with glass powder

Abstract

Abstract: The nickel-based alloy/glass powder composite coating was prepared on the surface of 45 steel by flame spraying technology. The coating was analyzed by scanning electron microscopy (SEM), energy spectrum analysis (EDS), X-ray diffraction analysis (XRD), microhardness analysis and pin-disk friction wear test. The effects of the amount of glass powder on the microstructure, phase composition, hardness and tribological properties of the nickel-based coating were studied. The results showed that the microhardness of the composite coating increases first and then decreases with the increase of glass powder content, and the maximum hardness reach 681 HV_0.2. The friction coefficient and volume wear rate of the composite coating decrease first and then increase. The friction coefficient of the composite coating with 10% glass powder addition is as low as 0.13, and the wear rate is as low as 0.21×10^－5 mm³/(N·m),which show that the addition of appropriate glass powder is beneficial to the improvement of the tribological properties of thenickel-based alloy coating.

Key words: flame sprayed, nickel-based coating, glass powder, tribological properties

CLC Number:

TG146

WEN Hong-wu, YU Lun, ZHANG Peng, CHEN Shao-juan LI Fu-shun, HAN Yan-bing. Preparation and tribological properties of Ni60 composite coating modified with glass powder[J]. Journal of Lanzhou University of Technology, 2024, 50(3): 14-20.

References

[1] 吕永刚,饶响,郭智威.仿生织构形态对缸套-活塞环摩擦学性能的影响 [J].润滑与密封,2022,47(5):52-59.
[2] 薛茂权,黄之德,倪贵华,等.活塞环表面处理及摩擦学性能研究进展 [J].电镀与涂饰,2020,39(21):1510-1513.
[3] 郝贠洪,刘永利,邢永明,等.钢结构镀锌涂层冲蚀磨损表面形貌及粗糙度 [J].中国表面工程,2017,30(1):56-62.
[4] 杨颖,水露雨,张瑜,等.镍基涂层的制备方法及应用 [J].金属功能材料,2013,20(3):49-53.
[5] 胡朔,万骁.柴油机活塞环故障分析及处理 [J].中国设备工程,2021(4):59-60.
[6] TORGERSON T B,HARRIS M D,ALIDOKHT S A,et al.Room and elevated temperature sliding wear behavior of cold sprayed Ni-WC composite coatings [J].Surface and Coatings Technology,2018,350:136-145.
[7] KUMAR H,RAMAKRISHNAN V,ALBERT S K,et al.Friction and wear behaviour of Ni-Cr-B hardface coating on 316LN stainless steel in liquid sodium at elevated temperature [J].Journal of Nuclear Materials,2017,495:431-437.
[8] 张楠楠,曹文慧,林丹阳,等.等离子喷涂NiCr/Cr₂C₃,Ni/C及其复合涂层的耐磨性能 [J].沈阳工业大学学报,2019,41(1):36-41.
[9] DHAVAL P,PINA B,RAGESH B.Development of FeV-WC Ni Cr B Si coating on stainless steel using HVOF process [J].Science Direct,2022,66:2008-2011.
[10] 陈枭,张晓敏,陈珑,等.超音速火焰喷涂TiB₂- 40Ni 涂层的组织和耐磨性 [J].2014,39(12):107-109.
[11] NA M J,YANG H,JUNG H J,et al.Robust hydrophobic surface driven by Al₂O₃/Glass composite coatings [J].Surface and Coatings Technology,2019,372:134-139.
[12] 周红霞,李成新,李长久.冷喷涂制备钛及钛合金涂层研究进展 [J].中国表面工程,2020,33(2):1-14.
[13] 刘晓丽,李明.超音速火焰喷涂纳米结构WC-Co涂层研究进展 [J].科技创新导报,2018,15(1):104-105.
[14] 陈洋,储茂友,王力军,等.超音速火焰喷涂制备Cr₂AlC涂层组织性能研究 [J].稀有金属,2012,36(4):568-573.
[15] CHEN H.Microstructure characterisation of unmelted particles in a plasma sprayed CoNiCrAlY coating [J].Materials Characterization,2018,136(5):444-451.
[16] 潘秋红,刘浩,董则防,等.Mn元素含量对富铁8系铝合金铸轧板组织的影响 [J].材料热处理学报,2022,43(2):33-40.
[17] 杨效田,周俊,王新华,等.Cu含量对Ni基定向合金涂层组织与摩擦学性能的影响 [J].稀有金属材料与工程,2022,51(4):1420-1426.
[18] MIAO X J,WU M P,CUI C,et al.Microstructure and water erosion resistance of in situ synthesized (TiB_x+TiC)/Ti composite coatings produced by laser cladding [J].Journal of Materials Research and Technology,2023,23:4089-4104.
[19] 杨效田,魏亨利,周俊,等.重熔温度对Ni60/WC定向结构涂层微结构演变的影响 [J].哈尔滨工程大学学报,2022,43(4):587-592.
[20] 邱翔.冷喷涂增材制造A380铝合金性能研究 [D].合肥: 中国科学技术大学,2020.
[21] 何玲,赵凡,李文生,等.SiO₂包覆对爆炸喷涂自敏涂层发光和摩擦性能的影响 [J].兰州理工大学学报,2020,46(6):16-21.
[22] 程皓然,王勋,李瑶林,等.单组分耐高温纳米陶瓷涂料的制备与性能研究 [J].中国涂料,2018,33(5):56-60.
[23] QIN B D,ZHOU S G,CHEN H,et al.Superior corrosion and wear resistance of AZ91D Mg alloy via electrodeposited SiO₂-Ni-based composite coating [J].Materials Chemistry and Physics,2022,283:126001.
[24] 刘占京,武海龙,田鹏辉,等.单组分自干水性耐高温防腐涂料的制备 [J].现代涂料与涂装,2020,23(7):8-10,14.
[25] 马利杰,屈海涛,马尊严,等.高体分铝基碳化硅超声振动钻削的内孔表面质量试验研究 [J].工具技术,2023,57(2):33-38.
[26] LOU M,WHITE D R,BANERJI A,et al.Dry and lubricated friction behaviour of thermal spray low carbon steel coatings:effect of oxidational wear [J].Wear,2019,432-433:102921.

Preparation and tribological properties of Ni60 composite coating modified with glass powder

PDF

Knowledge

Abstract

Cite this article

share this article

References

Related Articles 2

Recommended Articles

Metrics

Comments

[1]	WU Duo-ming, WANG Jin-man, WANG Xin, SHI Xu-dong. Effect of glass powder/silica fume mixture on durability of concrete under corrosive environment [J]. Journal of Lanzhou University of Technology, 2022, 48(3): 27-34.
[2]	CHEN Ling-ling, YAN Cheng-qi. Tribological properties of Ni-Al-Mo composite coating on Al alloy surface preparation by mechanical milling [J]. Journal of Lanzhou University of Technology, 2022, 48(1): 8-13.