进口压力对正开口配流盘轴向柱塞变量泵斜盘力矩的影响

兰州理工大学学报 ›› 2020, Vol. 46 ›› Issue (1): 44-47.

进口压力对正开口配流盘轴向柱塞变量泵斜盘力矩的影响

王建森¹, 李培勇¹, 陈波¹, 李理¹, 于昕海²

1.兰州理工大学能源与动力工程学院, 甘肃兰州 730050;
2.中船重工重庆智能装备工程设计有限公司, 重庆 400120

收稿日期:2017-10-27 出版日期:2020-02-28 发布日期:2020-06-23
作者简介:王建森(1973-),男,甘肃华池人,博士,副教授.
基金资助:
甘肃省科技计划资助(17JR5RA120)

Influences of inlet pressure of axial variable piston pump with cross porting disk on its swash plate moment

WANG Jian-sen¹, LI Pei-yong¹, CHEN Bo¹, LI Li¹, YU Xin-hai²

1. College of Energy and Power Engineering, Lanzhou Univ. of Tech. , Lanzhou 730050, China;
2. CSIC Chongqing Intelligent Equipment Engineering Co. Ltd. , Chongqing 400120, China

Received:2017-10-27 Online:2020-02-28 Published:2020-06-23

摘要/Abstract

摘要： 以某型具有正开口配流盘结构的闭式斜盘轴向柱塞变量泵为例,建立了单柱塞腔可压缩配流模型和斜盘力矩计算公式,得出配流盘吸排油过流断面面积变化曲线和单柱塞腔预升压、预卸压曲线,研究了不同进口压力下斜盘力矩的变化规律.结果发现随着泵进口压力的增大,斜盘绕三个坐标轴上所受力矩平均值均有不同程度的减小,其中变量力矩脉动幅值明显减小,适当增大入口压力有利于减小泵的变量力矩和减弱斜盘的机械振动.

关键词: 轴向柱塞变量泵, 正开口配流盘, 斜盘力矩, 入口压力

Abstract: Taking axial variable piston pump with close-type swash plate and a mechanism of cross porting valve plate as example, a compressible flow distribution model of single displacement chamber and computation formula of swash plate moment are established, the variation curves of the area of flow passage section of oil suction and discharge of the valve plate and the precompression and preexpansion curve of single displacement chamber are found, and the variation regularity of swash plate moment is studied under different inlet pressure. It is found out by its result that with increase of inlet pressure, the average value of the component of moment of swash plate on three coordinate axes will decrease to some extent, where the ripple amplitude of the variable moment will decreases obviously.Therefore, properly increasing inlet pressure will be of advantage for decreasing variable moment of pump and weakening the mechanical vibration of swash plate.

Key words: axial variable piston pump, valve plate with cross porting, swash plate moment, inlet pressure

中图分类号:

TH137.5

王建森, 李培勇, 陈波, 李理, 于昕海. 进口压力对正开口配流盘轴向柱塞变量泵斜盘力矩的影响[J]. 兰州理工大学学报, 2020, 46(1): 44-47.

WANG Jian-sen, LI Pei-yong, CHEN Bo, LI Li, YU Xin-hai. Influences of inlet pressure of axial variable piston pump with cross porting disk on its swash plate moment[J]. Journal of Lanzhou University of Technology, 2020, 46(1): 44-47.

参考文献

[1] 李壮云.液压元件与系统 [M].3版.北京:机械工业出版社,2005:86-95.
[2] 李书泽.轴向柱塞泵斜盘力矩分析 [J].柴油机械设计与制造,2001(1):24-26.
[3] 朱钰.轴向变量柱塞泵斜盘力矩的研究 [J].船舶工程,2008,37(6):74-76.
[4] 王建森,刘耀林,魏列江,等.轴向柱塞变量泵偏置斜盘力矩分析 [J].兰州理工大学学报,2017,43(3):44-49.
[5] SEENIRAJ G K,IVANTYSYNOVA M.Impact of valve plate design on noise,volumetric efficiency and control effort in anaxial piston pump [C]//ASME 2006 International Mechanical Engineering Congress and Exposition,Fluid Power Systems and Technology.Chicago:[s.n.],2006:7-84.
[6] MA Jien,FANG Youtong,XU Bing,et al.Optimization of cross angle based on the pumping dynamics model [J].Journal of Zhejiang University,2010,11(3):181-190.
[7] KIM T,KALBFLEISCH P,IVANTYSYNOV M,et al.The effect of cross porting on derived displacement volume [J].International Journal of Fluid Power,2014,15(2):77-85.
[8] 那成烈.轴向柱塞泵可压缩流体配流原理 [M].北京:兵器工业出版社,2003:20-25.
[9] 马吉恩.轴向柱塞泵流量脉动及配流盘优化设计研究 [D].杭州:浙江大学,2009.
[10] SEENIRAJ G K,ZHAO M M,IVANTYSYNOVA M,et al.Effect of combining precompression grooves PCFV and DCFV on pump noise generation [J].International Journal of Fluid Power,2011,12(3):53-63.
[11] SEENIRAJ G K,IVANTYSYNOVA M.A mutli-parametermulti-objective approach to reduce pump noise generation [J].International Journal of Fluid Power,2011,12(1)7-17.
[12] 钟鸣.A4V型轴向柱塞泵的动态特性分析 [D].哈尔滨:哈尔滨工业大学,2014.
[13] CHO I S,JUNG J Y.A study on the pressure ripple characteristics in a bent-axis type oil hydraulic piston pump [J].Journal of Mechanical Science and Technology,2013,27(12):3713-3719.